- Specialty Tractors (75-155 Engine HP)
- Utility Tractors (22.4 - 140 Engine HP)
- Utility Tractor Attachments & Implements
- Home & Workshop Products
The rotor bearings are now made of steel and have a three-lip seal to keep the dirt out and increase the life of the bearings.
The side and center bearings now have guards in order to avoid leaks and dust, increasing the life of the bearings.
A heavy-duty gearbox transfers power to the power-band drive belts through cross shafts with intermediate bearing supports:
|Select up to 4 models to compare specifications||
Drawn Flail Shredder
|Tractor PTO hp range||67-200 kW
|Tractor RPM||1,000 rpm|
|Number of knives||160|
|Knife mounting system||7.87 x 63.5 x 143 mm
0.31 x 2.5 x 5.63 in.
|Type||Heat-treated, reversible, side-slicer, hard-faced, tungsten-carbide knives optional|
|Tip speed||171 km/h
|Rotor speed||1,500 rpm|
|Rotor diameter||139.7 mm
|Rotor bearing||Sealed, self-aligning; piloted housing, auxiliary seals, and grease cavities|
|Bearing size||41.15 mm
|Belts||Power-band, triple 5VX|
|Hood thickness||6.35 mm
|Gauge wheels||7.60-15 infinitely adjustable row spaces|
|Cutting width||6.1 m
|Cutting height||7.6 to 25.4 cm
3 to 10 in.
|Transport width||2.4 m
|Transport length||7.3 m
|Constant velocity joint driveline||Yes|
Deflectors can be used on the front of the shredder to prevent cut material from being thrown forward. Rubber deflectors are recommended when shredding in rocky areas.
Additional gauge wheels can be ordered, if needed, for improved cutting performance.
The center divider minimizes the center strip of uncut material when clipping grass, idle acres, or non-row-crop crops.
This bundle is for use on all shredders with the following serial numbers:
NOTE: Previous machines did not have center-cut knives. To install, order them from Parts.