Table of Contents

ISOBUS VT

This John Deere display supports ISOBUS 11783 compatible controllers. These controllers can be viewed and operated within the ISOBUS VT (Virtual Terminal).

When an ISOBUS controller is connected, graphic files for the user interface are loaded into ISOBUS VT. Then ISOBUS VT provides a means for the operator to navigate through and operate all available functions of the ISOBUS controller.

Select Menu button to display a list of all connected ISOBUS controllers.

ISOBUS VT supports 10 virtual Softkeys. These softkeys appear along right hand side of ISOBUS VT.

Run Page Module

ISOBUS VT modules can be added to a run page using the Layout Manager application.

Modules are loaded from implement controller and are only available while controller is connected. The types of modules available are dependent on controller manufacturer. This display is capable of displaying ISOBUS VT version 3.

The following module sizes are available:

StarFire™ Receiver

StarFire™ Receiver help is accessible through Help Center.

Remote Software Updates

This display supports Remote Software Updates using the modular telematics gateway (MTG) on the machine. For further details refer to Software Manager.

Troubleshooting

If the interface for an ISOBUS controller does not display correctly:

If the interface still does not display correctly:

  1. Select settings at the top of ISOBUS VT application.

  1. Select Clean Up ISOBUS VT in advanced settings to clear stored ISOBUS controller user interface files.

The user interface is reloaded the next time the controller is connected.