Table of Contents

Configuring Selective Control Valves - Feature Mode

To set flow, upper and lower set points for a selected SCV.

A—Time Tab

B—Flow Tab

C—Automation Tab

D—Upper Setpoint Button

E—Increase Flow Buttons

F—Input Box

G—Decrease Flow Buttons

H—Lower Setpoint Button

 

Implement must be connected to tractor before key is turned on for feature mode to work.  If connected through the ISOBUS or implement connector, SCV(s) will automatically enter feature mode when turned on. Feature mode's available are:

 

  1. Connect tractor to implement.

  2. From SCV page, select desired Feature SCV module.

  3. Select Detent Flow tab (A) to adjust detent flow using increase button (D) or decrease button (F).

  4. Select Upper Setpoint tab (A) to adjust upper setpoint using increase button (D) or decrease button (F).

  5. Select Lower Setpoint tab (A) to adjust lower setpoint using increase button (D) or decrease button (F).