Table of Contents

Calibrations

In this application, calibrate sensors connected to machine.

For a tractor, perform wheel slip calibration and radar calibration within this application.

 

Radar Calibration

A radar device needs to be calibrated when it is first installed on machine, or when there is a difference between radar speed and actual ground speed. Currently, the system only supports John Deere dual beam radars.

 

Wheel Slip Calibration

When radar speed and wheel speed are mismatched, calibrate wheel slip. See Machine Monitor for more information about radar and wheel speed.

Perform calibration while driving with an unloaded machine on a hard, dry, clean, and level surface.

NOTE: Wheel slip calibration is only available when a radar device is connected and calibrated.