Table of Contents

FieldCruise™ Speed 1 and 2

 Automatically adjusts rpm's and throttle limit to varying loads. Two different FieldCruise™ speeds can be set, enabling operator to toggle quickly from one to the other.

A—FieldCruise™ Set Speed 1 Input Module

B—FieldCruise™ Set Speed 2 Input Module

C—FieldCruise™ Speed 1 On/Off Toggle Button

D—FieldCruise™ Speed 2 On/Off Toggle Button

E-FieldCruise™ On/Off Button

F—FieldCruise™ Set Speed Increase Buttons

G—FieldCruise™ Set Speed Input Box

H-FieldCruise™ Set Speed Decrease Buttons

 

Activate FieldCruise™

From Engine page, select FieldCruise™ Speed 1 (C) or 2 (D) On/Off toggle button. FieldCruise™ can also be activated using FieldCruise™ On/Off button (E) on CommandArm™. If CommandArm™  button is pressed, previously selected FieldCruise™ mode will be activated.

 

Adjust FieldCruise™ Set Speed

FieldCruise™ is an upper limit to engine speed. Engine speed can be adjusted from 1100 to 2150 RPM. Changes to FieldCruise™ take place immediately.

  1. From Engine page, select FieldCruise™ Set Speed 1 (A) or 2 (B) input module.

  2. When FieldCruise™ Set Speed 1 or 2 page appears, select desired speed by using FieldCruise™ Set Speed increase (F) or decrease (H) buttons. "++" and “- -” buttons increase or decrease values at higher rate than “+” and “-” buttons. FieldCruise™ Set Speed value appears in FieldCruise™ Set Speed input box (G).

 

FieldCruise™ with Different Transmission Modes

Change transmission mode by using Transmission Page on CommandCenter™ display. Following is how FieldCruise™ works with different transmission modes:

Full Auto: At full throttle, minimum engine speed is 1200 RPM with PTO off. Transmission downshifts and engine speeds up to FieldCruise™ set speed selected, to compensate for increasing workloads. Available engine speed range is 1200 RPM to FieldCruise™ set speed selected.

Custom: Minimum engine speed depends on ECO engine speed setting on transmission page. Transmission downshifts and engine speeds up to FieldCruise™ set speed selected, to compensate for increasing workloads. Available engine speed range is ECO engine speed setting to FieldCruise™ set speed selected.

Pedal (If Equipped): FieldCruise™ function is replaced by Engine Set Speed function. Engine speed stays constant at engine speed selected. Hand throttle will take over control of engine if moved out of position.

Manual: Operator sets engine speed using hand throttle. Engine speed stays constant, but limited by FieldCruise™ set speed.